5.3 Summary of Nuclear Power Plant Pumps -- Bibliography -- Chapter 6: Pumping Fluid-Solid-Particle Mixtures -- 6.1 Particle Measurements in a Centrifugal Slurry Pump -- 6.2 Rotary Blood Pump -- Bibliography -- Chapter 7: Ohio State Gas Turbine Lab -- 7.1 Shock Tube Test Facility -- 7.2 Large Spin Pit Facility -- Bibliography -- Chapter 8: Swiss Federal Institute Cavitation Research Facility at EPFL Lausanne -- 8.1 Description and Mission of Test Facility -- 8.2 Functioning of Cavitation Tunnel -- 8.3 Early Insights Gained -- Bibliography -- Chapter 9: Swiss Federal Institute Turbomachinery Lab at ETH Zurich -- 9.1 Low-Pressure Condensing Steam Turbine Research -- 9.2 Turbomachinery Stage Research -- Bibliography -- Chapter 10: Axial Location and Size of Progressing Shaft Cracks -- 10.1 State of the Art in Real Time Shaft Crack Detection -- 10.2 Basic Principles of the New CWRU Approach -- 10.3 Research Test Rig -- Bibliography -- Chapter 11: Cleveland State University Wind Turbine Tower -- 11.1 Amplified Velocity Significantly Increases Wind Power -- 11.2 Full-Scale Prototype Installations -- Bibliography -- Chapter 12: Compressor Refrigerant-Oil Separation Seal -- 12.1 Liquid Chiller Centrifugal Compressor, Seal, and Motivation -- 12.2 Seal Configurations Tested -- 12.3 Test Results Provide Product Improvement -- Bibliography -- Chapter 13: Combined-Impeller Turbine-Driven Pump -- 13.1 Description of the Combined-Impeller Turbine-Driven Pump -- 13.2 Test Loop -- 13.3 Performance and Endurance Test Results -- Bibliography -- Chapter 14: Water-Lubricated High-Speed Bearings -- 14.1 Product Description and Test Rig -- 14.2 Sample of Test Results -- Chapter 15: Aircraft Engine Compressor Blade Tip Rubs -- 15.1 Engine Blade-Tip-on-Shroud Contact in Service -- 15.2 Description of Test Rig